wanted: 100-120mm fork

As above, looking for a serviceble fork for an old Alu hardtail I am building up (turned it into a commuter for the missus but she ain't gonna be using it now she got her skinny tyres through work so I am rejigging it for me, just cos I can.)

Ideally an old reba/sid dual air, an old Pilot or Judy would also suit as I know my way around rock shox having had to do my own servicing for many years, but even an old Fox system will do as I now have Alfie and Rob at expert cycles to take them too if need be.

Ideally 1 1/8 steerer, length in excess of 180mm, 9mm qr, but 15mm bolt through also fine as I can convert the hubs. Don't mind if the lower legs (sliders) paint etc is worn as I will most likely re-spray them, but the stancions need to be in decent condition

I ain't looking for a freebie, but ain't gonna pay through the nose either, anyone got anything "lying around" they looking to sell?

I have a set of Revelations coil U-turn 80-130mm you could have for very little, one of the stanchions is a bit worn and I'd say bushings are gone at this stage but it worked well when I was taking it off the bike. Not sure about steerer lenght but it might be a bit less than 180mm. They were cut to fit lapierre head tube + stem with no spacers.
If you are going to Bunclody I can put it in the car and you can have a look then.

pm sent Max thanks

Hey Max just wondering if you managed to measure the steeper tube on the revelations? If it's 180 or above I'd be very interested in buying them off you.

Your pm box is apparently full so it bounced the one I sent ya:)
Thanks
Sent from my LT26i using Tapatalk

I'll measure it for you in the next hour and send you a picture as well.